Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.25mm

RS noliktavas nr.: 110-1982Ražotājs: UltimakerRažotāja kods: OBN001
brand-logo
View all in 3D printeru detaļas

Tehniskie dokumenti

Specifikācija

Product Type

Nozzle

For Use With

Olsson Block, Ultimaker 2+

Nozzle Material

Brass

Nozzle Size

0.25mm

Izcelsmes valsts

Netherlands

Produkta apraksts

Ultimaker 2 Jet Nozzles

The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Ultimaker Accessories

Noliktavas stāvoklis patreiz nav pieejams

Lūdzu pārbaudiet vēlreiz vēlāk

Noliktavas stāvoklis patreiz nav pieejams

€ 42,10

Katrs (bez PVN)

€ 50,94

Katrs (Ieskaitot PVN)

Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.25mm

€ 42,10

Katrs (bez PVN)

€ 50,94

Katrs (Ieskaitot PVN)

Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.25mm
Noliktavas stāvoklis patreiz nav pieejams

Tehniskie dokumenti

Specifikācija

Product Type

Nozzle

For Use With

Olsson Block, Ultimaker 2+

Nozzle Material

Brass

Nozzle Size

0.25mm

Izcelsmes valsts

Netherlands

Produkta apraksts

Ultimaker 2 Jet Nozzles

The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Ultimaker Accessories