ITT Cannon Dust Cap

RS noliktavas nr.: 273-5275Ražotājs: ITT CannonRažotāja kods: TNA14DCR0-02B / 192900-0394
brand-logo

Tehniskie dokumenti

Specifikācija

Produkta apraksts

Dust Caps

Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.

Neptune

Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.

Noliktavas stāvoklis patreiz nav pieejams

€ 9,30

€ 9,30 Katrs (bez PVN)

€ 11,25

€ 11,25 Katrs (Ieskaitot PVN)

ITT Cannon Dust Cap

€ 9,30

€ 9,30 Katrs (bez PVN)

€ 11,25

€ 11,25 Katrs (Ieskaitot PVN)

ITT Cannon Dust Cap
Noliktavas stāvoklis patreiz nav pieejams

Noliktavas stāvoklis patreiz nav pieejams

Lūdzu pārbaudiet vēlreiz vēlāk

DaudzumsVienības cena
1 - 19€ 9,30
20 - 39€ 8,40
40+€ 7,50

Tehniskie dokumenti

Specifikācija

Produkta apraksts

Dust Caps

Plastic dust-caps for plug and socket panel housings. Only the shell size is required to determine the correct cap. Caps include a plastic retaining strap.

Neptune

Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.